Hello PDF

Fairchild/ON Semiconductor FMS is available at WIN SOURCE. Please review product page below for detailed information, including FMS price. 2B 1 ? Fairchild Semiconductor Corporation FMS Low Cost Five Channel 4th Order Standard De?nition. FMS part, FMS sell, FMS buy, FMS stock, FMS TSSOP New&Original pars, , Fairchild, +, New parts and Stock on hand.

Author: Mezizilkree Keshura
Country: Andorra
Language: English (Spanish)
Genre: Politics
Published (Last): 19 July 2018
Pages: 241
PDF File Size: 19.21 Mb
ePub File Size: 11.47 Mb
ISBN: 963-5-26317-259-9
Downloads: 99231
Price: Free* [*Free Regsitration Required]
Uploader: Tojazilkree

Datums — A — and — B — to be determined at datum plane — H —. Dimension “b” does not include dambar protusion.

FMS datasheet & applicatoin notes – Datasheet Archive

Allowable dambar protusion shall be 0. The worstcase sync tip compression due to the clamp will not exceed 7mV. Dimensions “D” does not include mold flash, protusions or gate burrs. When the input is AC-coupled, the diode clamp will set the sync tip or lowest voltage just below ground.

  BIOTEK ELX808 PDF

For multi-layer boards, use a large ground plane to help dissipate heat? For variation with an odd fairchils of leads per side, the “center” lead must be coincident with the package centerline, Datum A. AC-coupled inputs and outputs External video source must 7. Frequency Response 10 5 0 -5 2 1 Figure 2.

Circuite integrate

DC-coupling the outputs removes the need for output coupling capacitors. DC-coupled inputs, AC-coupled falrchild 0V – 1. For optimum results, follow the steps below as a basis for high frequency layout: Care must be taken not to exceed the maximum die junction temperature. F ceramic bypass capacitors? Dimensions “D” and “E1” to be determined at datum plane — H —. Dambar connot be located on the lower radius of the foot. Refer to the Layout Considerations section for more information.

Interlead flash or protusion shall not exceed 0.

If the input signal does not go below ground, the input clamp will not operate. Typical application diagram FMS Rev. Terminal numbers are shown for reference only. The FMS is speci? Minimum space between protusion and adjacent lead is 0.

  FM 23-90 MORTARS PDF

The value may need to be increased beyond ? The internal pull-down resistance is k? In addition, the input will be slightly offset to optimize the output driver performance.

Price 3 RON – 5 RON

F capacitor within 0. Following this layout con? The outputs can faorchild AC or DC-coupled single ? Mold flash protusions or gate burrs shall not exceed 0.

Typical voltage levels are shown in the diagram below: The offset is held to the minimum required value to decrease the standing DC current into the load.

For 2 layer boards, use a ground plane that extends beyond the device by at least 0. Dimension “E1” does not include interlead flash or protusion. AC-Coupling Caps are Optional.

F, all outputs AC coupled with ?